Where does an ioda mount in a kbda drive

Where does an ioda mount in a kbda drive manuals#
Where does an ioda mount in a kbda drive manual#

It is recommended that a 40 Amp fuse or circuit breaker be installed on each AC line conductor not at ground potential. The KBRG-255 does not contain AC line or armature fusing. Note: J8 must be set to вЂњS/LTвЂќ position for speed control operation.ДЄll trimpots have been factory set in accordance with figure 1, page 3. For torque control, set J7 to TRQ position. Jumper J7 is factory set for speed control operation (SPD). Connect half voltage field wires (180 volt motors with 100 volt fields) to F+ and L1. Connect full voltage shunt field wires (180 volt motors with 200 volt fields) to F+ and F. Connect motor armature leads to M1+ and M2-.Дў. Connect ground wire (earth) to green ground screw.ДЎ. AC Line вЂ“ Wire AC line voltage (230VAC в‘0%, 50/60 Hz). You must read the Safety Warning before proceeding.ДЄ. These instructions are to be used as a reference only and are not intended to replace the detailed instructions provided herein. IMPORTANT вЂ“ You must read these simplified operating instructions before you proceed. ! KBRG-255 SIMPLIFIED OPERATING INSTRUCTIONS Setting Mode of Drive (Speed or Torque Control). Simplified Setup and Operating Instructions. Models KBRG-225D and KBRG-240D Logic Board Layout See Figure 2, on page 2, for Model KBRG-255 Logic BoardвЂ™s Trimpot and Jumper location changes. See Figure 1, below, for Models KBRG-225D and KBRG-240D Logic BoardвЂ™s Trimpot and Jumper location changes.

Where does an ioda mount in a kbda drive manuals#

The Parts Lists and Schematics in the manuals no longer apply to these controls and should not be used. The General Performance Specifications, Electrical Ratings, Mechanical Specifications, and Connection Diagrams have not changed. The OFFSET and TCL trimpots have been moved to be aligned with the other trimpots. These Controls have been Converted to Surface Mount Technology (SMT) For further assistance, contact our Sales Department at 95 or Toll Free at 80 (outside Florida). The manuals must be read and understood before operating these controls. A40260 and A40287) until the new manuals are available. This supplement is for Models KBRG-240D, KBRG-225D, and KBRG-255 Installation and Operation Manuals (Part Nos.

Where does an ioda mount in a kbda drive manual#

Installation and Operation Manual Supplemental Information